10
1. Press MENU/SELECT and press or to select BACKLIGHT?
setting. Then, press MENU/SELECT.
2. Select ON, OFF, or AUTO. If you select AUTO, the backlight turns on
for 10 seconds when a key is pressed, an alert is received, or the AC
adapter is plugged in.
3. Press MENU/SELECT again and press to exit.
1. Unplug the AC adapter and remove the backup batteries.
2. While holding down WEATHER/SNOOZE, plug the Hazard Alert
Radio’s AC adapter into an outlet or install batteries. USER SETUP
displays and the radio beeps. Then release WEATHER/SNOOZE.
3. Press MENU/SELECT to clear the memory and restore the factory
settings. DEFAULT displays. Wait 5 to 10 seconds until USER SETUP
displays.
4. Unplug then plug in the AC adapter and install batteries. SET
LANGUAGE displays. You must reinitialize the radio (see pages 2-3).
resetting your hazard alert radio
1. Press MENU/SELECT and press or until SIG REMINDER
displays. Press MENU/SELECT to enable or disable it. (% displays
when enabled and
Í
displays when disabled.)
2. Press to exit.
• Press any button to mute signal loss reminder alert. If a
signal is detected for less than 10 minutes and lost again, no
signal loss reminder will sound.
• If the signal is lost , SIGNAL LOSS appears and
Ê
ashes
on the display. WARNING and ADVISORY alert LEDs ash
alternatively, and WATCH LED lights.
signal loss reminder setting
To Next Page
Loading...
