Radio Shack CCR-81 Operation Guide

24
10. (In this example, the filename ADDITION is used. Be sure to use the
actual filename of the program you want to use with the Network 3.)
When the screen reads:
Ready
Ready
You type:
OJ [Q] oo [ID c::J oo [ID [ID rn rn rn [Q] oo c::J
!ENTER!
~ [ID [A] [yJ ~ [] [A] [ID [ID [I [I] [I] [QJ [NJ •
!ENTER!
The recorder will now start running and the program will be saved on the
cassette tape.
11. When "Ready" reappears on the screen and the cassette recorder goes off,
press the STOP button on the recorder.
12.
Press REWIND. When the tape counter is again at zero, press STOP.
13.
Press the PLAY button on the recorder.
14.
Remove the diskette from the disk drive.
15.
Place the Network 3 software diskette in the drive with the label facing up
and the square notch to the left. Close the disk drive door.
16.
Press the orange Reset button.
17.
When the screen reads:
You type:
TRSDOS Ready
[BJ oo ~ rn ~ 1 ENTER 1
How Many Files?
!ENTER!
Memory Size?
!ENTER!
18. When the screen reads:
You type:
Ready
~ 11] [Q] [A] [ID I ENTER I
19. The cassette recorder will come on and begin to load the program. If the
program is loading properly, two asterisks will appear in the upper right
corner of the screen. The right asterisk will blink.
If the asterisks do not appear aftvr s"Nvral seconds:
•
press the I BREAK I key on the computer
• press the STOP button on _the recorder
• turn the volume on the recorder a little higher
•
repeat Steps 12 and 13 above and then continue from Step 18 above.

Radio Shack CCR-81 Specifications

General

Brand	Radio Shack
Model	CCR-81
Category	Desktop
Language	English