13
Manual Recording
To control when recording begins and ends, manually, set VOX/ TONE to OFF,
then press RECORD to begin recording. Use
and the pause control to stop and
pause your recording.
Using an External Microphone
1. Connect an external microphone (not supplied) with a
1
/8- inch (3.5mm) plug to
the recorder’s MIC jack as an alternative to using the built-in microphone. This
automatically overrides the built-in microphone.
2. Set VOX/TONE to ON for VOX recording, or to OFF for manual recording.
3. If the microphone has an
ON/OFF remote control switch, connect the
microphone to the REM and MIC jacks. Then you can start and stop recording
with the switch on the microphone.
Recording from External Sources
You can record directly from a tuner, radio, or a TV that has a 1/8-inch (3.5mm) jack.
1. Use a dubbing patch cord (not supplied) to connect the recorder’s MIC jack to
the headphone output jack of an external component.
2. Set VOX/TONE to OFF, then proceed with manual recording.
To Next Page
Loading...
Need help?
General
