11Connecting Inputs
CONNECTING SPEAKERS
You can connect two speakers or a sub-
woofer to the amplifier.
Important:
Before you make the con-
nections, make sure
BRG/ST
on the side
of the amplifier is set to
ST
.
Preparing the Speaker Wires
Caution:
You must connect a separate
wire to each speaker terminal as de-
scribed in the following procedures.
Only use a common ground wire or
chassis ground if your auto sound sys-
tem is wired for it.
Notes:
• We recommend you use 16- or 18-
gauge marked or color-coded wires
to help you correctly connect the
speakers to your amplifier.
Color-coded wires have a stripe run-
ning down one of the conductors or
different colored insulation for each
conductor. Your local RadioShack
store has a wide selection of
speaker wire to choose from.
• For the maximum bass response
and the best overall performance,
keep your speakers properly
phased (connect + to + and – to –).
1. With the speakers placed in their
approximate locations, run one wire
from each speaker to the amplifier.
If you are connecting a subwoofer,
run two wires from each of the sub-
woofer’s terminals to the amplifier.
2. Separate each wire’s two conduc-
tors at both ends for a length of
about 4 inches (112 mm).
3. Strip the insulation from the ends of
each conductor to expose about
1
/
4
inch (6 mm) of wire. Twist the ends
to secure loose strands.
4 Inches
1
/
4
Inch
12-2016.fm Page 11 Monday, April 10, 2000 4:33 PM
To Next Page
Loading...
