19Care and Maintenance
Replacing the SFE-Type Fuse
1. Disconnect the cable from the vehi-
cle’s negative (–) battery terminal.
2. Open the fuse holder on the red
power cable by pushing the holder’s
two halves together, then twisting
them as shown until they spring
apart.
3. Remove the fuse. If it is blown,
replace it. Use only an SFE-type 30-
amp fuse (available through your
local RadioShack store or at many
automotive supply stores).
4. Insert the fuse into the fuse holder’s
longer half. Reassemble the fuse
holder by pushing the holder’s two
halves together, then twisting them
(opposite the direction used in Step
2) until they latch together.
5. Reconnect the cable to the vehicle’s
negative (–) battery terminal.
Replacing the Blade-Type Fuse
1. Disconnect the cable from the vehi-
cle’s negative (–) battery terminal.
2. Grasp the fuse’s plastic end and pull
it out.
3. If the fuse is blown, replace it. Use
only a blade-type automotive 30-
amp fuse (available at your local
RadioShack store).
4. Grasp the fuse’s plastic end and
push it in.
5. Reconnect the cable to the vehicle’s
negative (–) battery terminal.
Fuse
12-2016.fm Page 19 Monday, April 10, 2000 4:33 PM
To Next Page
Loading...
