3) Other often seen problems
Radio cannot turn on
Noise is always heard
The voice of another group can be heard
The operating time becomes short,
even the battery is fully charged
Unable to communicate with the
transceivers of the same group
Other radios cannot receive the
TX signals or receive signals in a
low volume
Appendix A -- RF Energy Exposure and Product
Safety Guide for Portable Two- way Radios
ATTENTION!
Before using this radio, read this guide which contains important operating instruc-
tions for safe usage and RF energy awareness and control for compliance with
applicable standards and regulations.
This two-way radio uses electromagnetic energy in the radio frequency (RF)
spectrum to provide communications between two or more users over a distance. It
uses radio frequency (RF) energy or radio waves to send and receive calls. RF energy
is one form of electromagnetic energy. Other forms include, but are not limited to,
sunlight and x-rays. RF energy, however, should not be confused with these other
forms of electromagnetic energy, which when used improperly, can cause biological
damage. Very high levels of x-rays, for example, can damage tissues and genetic
material.
Visit Radioddity.com For Downloads And Help
26
Visit Radioddity.com For Downloads And Help
27
1. The battery is out of power. Replace or
recharge the battery.
2. The battery is installed incorrectly.
Remove it and install again
Replace the battery.
1. Confirm the QT/DOT is the same
2. The distance is out of range
1. Switch the volume knob to the highest
2. The microphone may be damaged, send it
to the local dealer for checking
The distance is out of range
Turn on the radio in shorter distance and
try again
Change all QT/DOT of the group
To Next Page
Loading...
Need help?
General
