1. Align the two grooves of battery and the guide rail on the back of aluminum shell, ensuring
full contact and in parallel, then push the battery up to the radio base along the rail on the
back of aluminum shell, until the battery latch locks up.
2. To move the battery, please make sure the radio is closed, push the battery latch down,
and then push the battery out from the radio.
Installing and uninstalling of supplied accessories
Installing/Removing the battery
03
Installing and removing the antenna
1. Align the threaded end of antenna and the treaded hole at the top of radio, rotate the antenna
clockwise until it is tight.
2. To remove the antenna, rotate it counter-clockwise until the antenna spirals out.
04
To Next Page
Loading...
