Radiodetection RD8200 SG - Data Management and System Configuration; Exporting Survey Data; System Menu Navigation; Locator Menu Options Explained

20 21
System MenuSend data from PointMan to email
1. Once you have
completed the survey,
click ‘Finish’ in the
bottom right hand
corner of the app.
2. Then click on ‘Send’.
3. Select the survey and
select OK on the ‘Send’
pop-up.
4. Select all of the
attachment types and
click OK.
The RD8200SG locator and transmitter
menus allow you to select or change system
options and it is important to set up the
system according to regional / operational
requirements. Once entered, the menu is
navigated using the arrow keys. Navigation
is consistent on both the transmitter and
the locator. When in the menu, most on-
screen icons will temporarily disappear and
the menu options will appear in the bottom
left-hand corner of the display. The right
arrow enters a submenu and the left arrow
returns to the previous menu.
Note that when browsing the locator menu,
the
and
keys act as left and right
arrows. When browsing the transmitter
menu, the
and keys act as left and
right arrows.
To navigate menus:
1. Press the key to enter the menu.
2. Use the
or keys to scroll through
the menu options.
3. Press the
key to enter the option’s
submenu.
4. Use the
or keys to scroll through
the submenu options.
5. Press the
key to conrm a selection
and return to the previous menu.
6. Press the
key to return to the main
operation screen.
NOTE: When you select an option
and press the key, the option will be
enabled automatically.
Locator menu options
• VOL: Adjust the speaker volume from
0 (mute) to 5 (loudest).
• SMLOG: enable or disable Bluetooth used
for sending Survey Measurements, reset
BT, pair with external device, select BT
protocol,send stored survey measurement
logs and deleting stored logs.
• ILOC: Enable, disable, reset or pair iLoc
connections.
• GPS: Disable GPS module,reset GPS,
enable or disable BT comms to correction
service.
• CDR: Perform a Current Direction (CD)
Reset. (Alternatively press and hold
the
key when in CD mode).
• UNITS: Select metric or imperial units.
• TICKT: Enable or disable ticketing system.
• UTIL: Enable or disable utility selection.
• ULIST: Utility selection.
• LANG: Select menu language.
• POWER: Select local power network
frequency: 50 or 60Hz.
• ANT: Enable or disable any antenna
mode with the exception of Peak.
• FREQ: Enable or disable individual
frequencies.
• ALERT: Enable or disable StrikeAlert
™
.
• BATT: Li-Ion auto-selects when
connected.
• ARROW: Select Null or proportional
Guidance arrows in Peak+ mode.
• COMP: Enable or disable display of the
Compass feature.
• VALRT: Enable or disable the vibration
feature.
• AUDIO: Select High or Low sound levels.
• SWING: Enable or disable Swing
measurement.
• INFO: Software version, run Self-Test,
display the date of the most recent
service recalibration (CAL) or the most
recent eCert calibration.
5. Type your email address
and send the les.