14 15
Pairing Locator Bluetooth to Android Device
5. Select the 82SG-XXXXXX in
Available devices.
6. When asked for a passkey, enter 1234.
7. 82SG-XXXXXX should now be shown
in Paired devices.
Bluetooth error codes
If an error occurs when attempting to perform any Bluetooth command using the locator
to the transmitter or the locator to a PC or paired device, the LCD will display a code to
help you resolve the problem on the locator.
The codes are as follows:
Please refer to the 'To navigate menus'
section on p.21 for assistance.
1. Set unit for pairing mode: Press >
> SMLOG >
> > PAIR >
.
2. Press the
key on locator to start
pairing cycle.
3. On the Android device, navigate to
Settings > Bluetooth.
4. Scan for a new device to add to the list
of paired devices.
BT Code Description
BT001 Bluetooth not configured for this unit.
BT002 Internal Bluetooth error.
BT003 Locator not paired with transmitter.
BT004 Locator not paired with PC / external compatible device.
BT005 Paired but connection attempt failed. Power cycling may be required.
BT006 Corrupt response received from transmitter.
BT007 Indeterminate response received from transmitter.
BT008 No response received from transmitter.
BT010 Transmission to paired device failure.
BT012 No response received from PDA or PC/Phone.
BT014 Paired but connection attempt failed with PC/PDA. Retry or Power cycling may
be required.
TX?? Command not supported by transmitter
To enable survey grade accuracy,
Bluetooth pairing to both the locator
and GNSS antenna is required.
To Next Page
Loading...
