RadioLink Electronic Ltd
www.radiolink.com
Note:
1. When the transmitter and receiver are powered on, if binding is not successful or the signal is lost, the
LED of R8FG will keep flashing to notify.
2. The close distance between the transmitter and receiver may cause a signal block, which leads to
unsuccessful binding or signal loss. After the binding is successful, if RC8X and R8FG receiver are too
close (for example, within 60 centimeters), the signal may also be lost because of signal block. Bring
RC8X transmitter and R8FG receiver farther apart, the signal loss will disappear automatically.
5. Telemetry
R8FG can return the real-time flight information such as RSSI, receiver voltage and model battery
voltage.
In order to enjoy this function, please upgrade RC6GS(3-position switch version) with the firmware
RC6GS_RadioLink_bin_1d15_V_6_1_2 downloaded via https://www.radiolink.com/rc6gs_firmware
Or upgrade RC4GS(produced after 2018-01-01) with the firmware
RC4GS_RX_RadioLink_bin_2f50_V_6_0_1 downloaded via https://www.radiolink.com/rc4gs_firmware
If you are using RC8X, RC6GS V3, RC6GS V2, RC4GS V3 or RC4GS V2, the default firmware supports
telemetry function.
Power on RC8X and R8FG receiver. The signal and other telemetry information will be displayed in the
home page of RC8X if the binding is successful and the telemetry cable is connected correctly.
RC8X home page:
To Next Page
Loading...
