Radiolink Electronic Ltd
www.radiolink.com
6
6. Click “START” and the process bar becomes green. When the green bar goes to the end and shows PASS,
the firmware is upgraded with success.
7. When upgrade with success, close the software and T8S will make three DEE sounds.
Chapter 3 Parameters Setup via Mobile
3.1 Android APP Installation
Scan the QR code on the right or click
http://www.radiolink.com.cn/firmware/transmitter/RadiolinkT8S_BLE_502_2019
1106.apk to download the android app to setup T8S parameters by Bluetooth
connection.
Note T8S parameters setup APP is only available on Android mobiles.
3.2 Connection
1. When the installation of parameter setup app
is complete, short press the power button to turn
on T8S
2. Click to enter the APP, a message
will pop out to ask for permission to turn on the
Bluetooth function
To Next Page
Loading...
