To Next PageTo Next Page
Need help?Do you have a question about the RadioLink RC6GS V3 and is the answer not in the manual?
General| Channels | 6 |
|---|---|
| Telemetry | Yes |
| Channel Bandwidth | 400KHz |
| Spreading Spectrum | DSSS |
| Screen | 128*64 LCD |
| Antenna Length | 106mm |
| Display | LCD |
| Frequency | 2.4GHz |
| Range | Up to 600 meters |
| Power Supply | 4x AA batteries or 2S LiPo |
| Operating Voltage | 4.8V to 15V |
| Control Distance | 600m (in open area) |
| Receiver | R7FG |
| Simulator | Yes |
| Battery | 4x AA batteries or 2S LiPo |
| Adjacent Channel Rejection | ≥36dBM |
Details the components and features of the RC6GS V3 transmitter.
Lists the technical specifications of the R7FG receiver.
Provides instructions on how to install and bind the R7FG receiver.
Explains the different operating modes of the R7FG receiver.
Guides users on setting up the gyro function on the R7FG receiver.
Describes how to view real-time signal strength and RSSI on the transmitter.
Explains how to monitor model battery and receiver voltage via telemetry.
Details the information displayed on the transmitter's LCD screen.
Instructions for changing the transmitter's display language.
How to select and manage different model memories on the transmitter.
Adjusts servo travel limits for steering, throttle, and auxiliary channels.
Modifies steering servo sensitivity around the neutral and end points.
Controls the speed at which the steering servo responds to input.
Adjusts throttle servo sensitivity for throttle and brake sides.
Manages throttle servo delay for smoother operation and reduced wheel spin.
Enables pulse braking for improved cornering with 4WD vehicles.
Adjusts the throttle servo's initial jump from neutral for quicker response.
Raises engine idling speed for easier starting of gas-powered cars.
Adjusts the neutral position of steering, throttle, and other servos.
Reverses the direction of servo operation for selected channels.
Adjusts servo travel amounts simultaneously for steering and throttle.
Fine-tunes the braking effect by adjusting the brake amount.
Allows mixing control signals between arbitrary channels.
Customizes assignment of control switches to auxiliary channels.
Allows users to name and manage model memories.
Sets alarms for low voltage and signal strength for safety.
Adjusts gyro sensitivity and VR mixing for enhanced stability.
Configures servo and throttle behavior in case of signal loss.
Manages multiple receivers with independent IDs for easier control.
Configures the DSC port for simulator or FPV goggles connection.
Provides timing functions for training or gaming.
Resets all model memory data to original factory defaults.
Step-by-step guide to update the RC6GS V3 firmware.
Instructions for calibrating the transmitter's steering wheel and throttle.
Explains how to use the throttle delay function.
Demonstrates how to use the timer function for timing.
Guide on setting dual rate for steering and throttle.
Tutorial on using the End Point Adjustment (EPA) function.
How to configure alarms for multiple models.
Tutorial on using the ID Seed function for multiple receivers.
Guide to setting up the cruise control function.
Instructions for setting up the head track function.
Guide on how to set up an FPV monitor with the transmitter.
Information on transmitter power options and low power settings.
Steps for connecting the RC6GS V3 to a TBS Crossfire system.
Guide on setting up LK-A and LK-D buttons.
