RadioLink Electronic Ltd
www.radiolink.com
2.14 Steering/Throttle Dual Rate "D/R"
Dual rate
The steering left and right servo travels are adjusted simultaneously. When
you want to increase the servo travel, adjust the + side. When you want to
decrease the servo travel, adjust the - side.
The servo travel amount of all channels can be reduced by Dual Rate
setting. Dual rate function is different from EPA, which requires the travel
amount on both sides of the channel to be set separately. Setting the rate of
D/R will affect the left and right travel amount at the same time. For example,
after setting a smaller throttle value, the travel amount of the model forward
and brake will be reduced at the same time, the setting range is 0-100, the
default is 100.
Dual Rate Setting:
(1) Long press "Exit" and "Enter" button simultaneously for one second to
enter the function menu of RC6GS V3. Press "Inc(+)" button at the bottom of
the screen to move the cursor to "13. D/R", and then press " Enter” button to
enter the function setting interface.
(2) Switch setting: Set a switch or button to switch in different travel amount
of each channel.
A. You can set SWA, SWB, SWC, SWD, or the lock modes of these four
switch buttons LK-A, LK-B, LK-C, LK-D.
B. "NULL" means no switch assigned. After setting the travel amount of the corresponding channel, the
transmitter will always execute the set value by default.
C. UP (up)/DOWN (down)/CNT (central): It indicates the position of the selected switch. Push/Press the
switch to different positions to set different travel amount.
D. Setting method: Press "Dec(-)" or "Inc(+)" button at the bottom of the screen to move the cursor to
"NULL" next to the switch, then press "Enter" button, the corresponding setting starts to flash, then press
"Dec(-)" or "Inc(+)" button to select the switch or button to be set, and press "Enter" button to confirm the
option after the selection. The switch setting stops flashing and the switch setting is complete.
(3) Set the travel amount of each channel: press “Dec(-)” or “Inc(+)” button to move the cursor to the rate next
to the channel, and then press the “Enter” button, the corresponding value starts to flash , and then press
“Dec(-)” or “Inc(+)” button to adjust the rate value. After setting, press "Enter" button, the rate value stops
flashing, and the channel rate value is set.
(4) Press "Exit" to return to the home page.
Example:
1. Set a 3-way switch such as SWB or SWC.Switch three different values of travel amount when SWB or
SWC be switched to the upper, central and lower positions.
Setting method:
Push SWB/SWC switch to the UP position (UP will be displayed in the upper right corner of the screen), press
"Dec(-)" or "Inc(+)" at the bottom of the screen to adjust the dual rate value of the channel to be set. When
SWB/SWC switch is switched to the UP position, the transmitter will execute the preset dual rate value;
Push SWB/SWC to the central position (CNT will be displayed in the upper right corner of the screen), the
method is the same as above;
To Next Page
Loading...
Need help?
General
