RadioLink Electronic Ltd
www.radiolink.com
or “Inc(+)” button to choose the character you desired.Press“Enter” button again, the next character of current
name will blink. Reset other characters of current name in same manner.
(3) After accomplishment of naming, all characters of current name will stop blinking, the new name will be
stored automatically.
(4) When ending setting,return to the initial screen by pressing“Exit”button twice.(the new setting model name
will appear on the initial screen)
2.19 ALARM(Safety alarm for low voltage and Signal strength )
Each model can independently set low voltage and RSSI value alarms, but the alarm functions of RATE is not
yet available.
When the voltage of the transmitter,
receiver, vehicle battery, and RSSI signal
strength are lower than the set value,
there will be a text displayed on the
transmitter screen and a "didi" sound dual
alarm prompt to remind you.
You can set the value in the "ALARM"
menu: Press “Exit” and “Enter”button at
the same time to enter menu, select the "19. ALARM" option, press “Enter”button to access the “ALARM”
function interface. The transmitter default alarm voltage is 7.2V, and it can be customized on 2-4S
battery .The receiver default alarm voltage is 4.0V, and the vehicle battery default alarm voltage is 11.1V.
The default alarm voltage of single-chip battery is 3.7V. For example, if you use a 3S lithium battery for your
model, then the low voltage alarm value should be set to 11.1V (3.7V×3S). The setting method of transmitter
and receiver is the same.
Transmitter voltage is low Receiver voltage is low RC model battery voltage is low
The RSSI alarm value is turned off
by default. Users can set it as the RSSI value corresponding to the farthest
safe distance of the actual control. For example, the farthest remote control
distance is 400m, the corresponding RSSI value is -85dBm, then you can set
the RSSI alarm value as -85dBm. When the vehicle is running, if the
transmitter battery or vehicle battery is exhausted, or the RSSI signal is week,
the vehicle will lose control. Therefore, when the alarm sounds, please stop
driving immediately and take the vehicle back, check the cause of the alarm,
and deal with it properly. The alarm prompt is as right:
To Next Page
Loading...
Need help?
General
