RadioLink Electronic Ltd
www.radiolink.com
How to check the timing of each lap: move the cursor to: L01-L30, press
the "Enter" button, the cursor starts to blink, and then press the "Dec(-)" or
"Inc(+)" buttons at the bottom of the screen to select the laps to check the
timing time. The corresponding timing lap and timing will be displayed in
the box below.
Display: CURRENT, the ON or OFF status of the timing function is only
displayed in the function menu of "Timer".
HOME PAGE, the ON or OFF status of the timer function is displayed both
in the "Home Page" and "Timer" function menu of the transmitter at the
same time.
2.25 Factory Reset “RESET”
RESET- Data reset function:
All the data for any model memory can be reset to original factory defaults.
Often this function is done to get a “fresh start” and clear the memory
before inputting new model settings.
(1) Enter the function menu and use “Dec(-)” or “Inc(+)” button to access
RESET function.
(2) Press “Enter” button to get into RESET function interface, the symbol
“YES” will blink.
(3) Press “Enter” key, the symbol “YES” will stop blinking, and the
transmitter will make three beeps. Then it will return to the initial screen
automatically. Now the model data is reset to the initial setting that is the default value set at the factory.
CAUTION: Resetting the current model memory will permanently erase ALL programming information for that
model. The data cannot be recovered. Do not reset the model unless you are certain you want to clear-out
that memory and start from scratch.
III. Tutorials
3.1 Firmware Update of RC6GS V3
Video tutorial
：
https://www.youtube.com/watch?v=XLyTnSlou-4
Firmware update steps:
1. Check the firmware version in the basic menu--LANGUAGE before firmware update.
2. Download the newest firmware in RadioLink official website. (https://www.radiolink.com/rc6gsv3_firmware)
To Next Page
Loading...
Need help?
General
