Radiolink Electronic Ltd
www.radiolink.com
6
6. Click “START” and the process bar becomes green. When the green bar goes to the end and shows PASS,
the firmware is upgraded with success.
7. When upgrade with success, close the software and T8S will make three DEE sounds.
Chapter 3 Parameters Setup via Mobile
3.1 Android APP Installation
Scan the QR code on the right or choose the file RadiolinkT8FB/T8S.APK in the
zip file downloaded via http://radiolink.com.cn/doce/Firmwares/T8S/T8Sparamsetuptools.rar
and install into an Android phone.
Note The version of T8S parameters setup APP is only available on
Android mobiles with V4.0 or above. Some Android phones (eg. OPPO R9s) need to activate the OTG function
to ensure successful connection (Activate Steps: Settings - Other settings - OTG Connection)
To Next Page
Loading...
