Mix name: Name setting Use the scroll wheel to select letters and numbers, and
press and hold the ENT key to switch between upper and lower case. Short press
the ENT key to set the next character.
Source: Long press the ENT key to pop up the input source category menu.
Weight: Channel travel amount, the range is -500 / + 500. The default value is
100. Negative values indicate reverse channel output.
Offset: Midpoint offset, you can add the offset of the input value, positive or
negative. Range is -500 / + 500
Trim: You can choose whether the fine-tuning is effective for this entry, or you
can define a fine-tuning that affects this article separately.
Curve: Curve settings
Adjust the stroke amount on one side with the midpoint as the boundary
Expo curve setting. Increasing a positive value will make the gimbal smoother
and smoother when approaching the midpoint, while increasing a negative value
will make the gimbal more acute when approaching the midpoint.
Positions above 0 (midpoint) follow the gimbal output, operations
below the midpoint are all fixed to the midpoint value of 0
The opposite of the previous one
Absolute values, negative values less than the midpoint will always
become positive values, and the actual performance is a V-shaped
curve
Below the midpoint 0 is fixed at midpoint 0, above the midpoint is
fixed at 100, the actual performance is that the gimbal becomes 0
and 100 to switch, there is no intermediate process
The opposite of the previous one
Above the midpoint is fixed at + 100%, and below the midpoint is
fixed at -100%. The actual performance is that the gimbal becomes -
100% and + 100% to switch. There is no intermediate process.
To Next Page
Loading...
