Mix name: Name setting Use the scroll wheel to select letters and numbers, and press and
hold the ENT key to switch between upper and lower case. Short press the ENT key to set
the next character.
Source: Long press the ENT key to pop up the input source category menu.
Weight: Channel travel amount, the range is -500 / + 500. The default value is 100.
Negative values indicate reverse channel output.
Offset: Midpoint offset, you can add the offset of the input value, positive or negative.
Range is -500 / + 500
Trim: You can choose whether the fine-tuning is effective for this entry, or you can define a
fine-tuning that affects this article separately.
Curve: Curve settings
Adjust the stroke amount on one side with the midpoint as the boundary
Expo curve setting. Increasing a positive value will make the gimbal smoother and
smoother when approaching the midpoint, while increasing a negative value will
make the gimbal more acute when approaching the midpoint.
Positions above 0 (midpoint) follow the gimbal output, operations
below the midpoint are all fixed to the midpoint value of 0
The opposite of the previous one
Absolute values, negative values less than the midpoint will always
become positive values, and the actual performance is a V-shaped
curve
Below the midpoint 0 is fixed at midpoint 0, above the midpoint is fixed
at 100, the actual performance is that the gimbal becomes 0 and 100 to
switch, there is no intermediate process
The opposite of the previous one
Above the midpoint is fixed at + 100%, and below the midpoint is fixed
at -100%. The actual performance is that the gimbal becomes -100%
To Next Page
Loading...
