1.6. Specifications
Size： 174*86*157.5mm
Weight： 355g（No battery）
Frequency： 2.400GHZ-2.480GHZ
Transmitting power： Module dependant
Antenna gain： 2db
Battery： 3.7V 18350 Lithium Ion
Charge port：USB-TypeC
Operation voltage：DC 6.6-8.4v
Range： > 2km @ 20dbm
Firmware： EdgeTX（Transmitter)
Channels： Up to 16 (Rx dependent)
Display：128*64 Monochrome LCD display
Gimbals： High precision potentiometer/ Hall-effect sensor (Package dependent)
External module：8Pin Nano Port
Upgrade method： USB/SD card & EdgeTX Companion PC software
1.7. Warranty and repair
Should any issues arise with your radio system's hardware, please keep the proof of purchase
and contact the retailer where you made the ZORRO purchase. . You may also visit our warranty
support page https://www.radiomasterrc.com/contact
The limited warranty covers defects in workmanship for one year from the date of purchase
1.8. Disclaimer
OpenTX/EdgeTX are open source firmware. No warranty or implied warranty is given for the
quality and reliability of this firmware. If not handled properly, the RC model can cause serious
injury or even death. If you decide to use OpenTX/EdgeTX firmware, you are solely responsible
for your model. Any injury or damage caused by using OpenTX/EdgeTX firmware The authors of
OpenTX/EdgeTX and RadioMaster assume no responsibility. Use with caution.
To Next Page
Loading...
