RADWAG X2 Series User Manual

- 20 -
8. WEIGHING OPERATION
Load a weighed object on a balance weighing pan. On stabilization of weighing result, indicated by
stability marker
visible on the left side of balance display, read the measurement result.
Record / printout of the measurement result is available on pressing <PRINT> key:
• for verified balances – only stable measurement result can be saved or printed (stability marker
visible on balance’s display),
• for non-verified balances – stable or unstable measurement result can be saved or printed
(regardless of stability marker
absence). If unstable measurement result is printed then it is
accompanied by question mark <?> in front of printed mass value.
8.1. GOOD WEIGHING PRACTICE
In order to ensure long lasting use of a balance plus correct and reliable measurement of weighed
loads, follow below procedures:
• Start the balance with no load on the weighing pan (permissible value of load on the weighing
pan on balance start is ±10% of its maximum capacity).
• Load the weighing pan steadily avoiding shocks:
YES
NO
• Place weighed loads centrally on the weighing pan:
YES
NO
• Avoid side loading, in particular side shocks:
NO
NO

RADWAG X2 Series Specifications

General

Brand	RADWAG
Series	X2 Series
Category	Laboratory Equipment
Display	LCD
Data Management	Yes
Connectivity	USB, RS 232, Ethernet, Wi-Fi
Calibration	External
Stabilization Time	≤3 seconds
Weighing Units	g, mg, ct, lb, oz
Power Supply	100 - 240 V AC 50/60 Hz
Operating Temperature	10°C to 40°C
Pan Size	90 mm
Operating Humidity	40% to 80% (non-condensing)