INSTALLATION
Select Location
Follow these Guidelines to select a location for the
Maxicom Interface Site Board (MISB) Cabinet.
Note: The MISB Cabinet is the same cabinet as
used for the ESP-LX PLUS Controller. Please
refer to your ESP-LX PLUS Installation,
Programming, & Operation guide for detailed
description of the mounting of the cabinet.
The MISB Cabinet requires a data and power cable con-
necting it to the ESP-LX PLUS Controller. This cable
includes 36" (91,4 cm) length designed to be outside the
two cabinets. Allow enough length for vertical passage
through electrical conduit prior to determining horizontal
length available.
It is recommended that you place the MISB cabinet not
more than 15" (38,1 cm) horizontally from the ESP-LX
PLUS controller cabinet. Allow at least 9
1
⁄2" (24,2 cm) of
horizontal clearance between the two cabinets, so the
hinged cabinet door can swing fully open to the left.
Ensure at least 6
3
⁄4" (17,2 cm) of clearance above the cab-
inet door so the hinge pin can be removed to service the
controller.
ESP-LX Plus Site Satellite Controller Addendum4
To Next Page
Loading...
Need help?
General
