RainFlo RF4 Series - Lamp Replacement (RF4 Systems); Lamp Replacement (RF5 & RF6 Systems); QR Codes

17|Page
Lamp Replacement (RF4 systems)
Aer the lamp is expired, it must be replaced with the same part number as indicated by the
label on the reactor. Begin replacing the lamp by unplugging the power for the controller, then
refer to Installaon, starng with step 11 (page 11) for instrucons on installing the new lamp.
To reset the mer in the controller, rmly hold down the buon on the controller for 10 seconds.
The controller will read “rSt3”, “rSt2”, “rSt1” and then beep. The buon can now be released, the
lamp countdown mer has been reset.
Lamp Replacement (RF5 & RF6 systems)
Aer the lamp is expired, it must be replaced with the same part number as indicated on the
Maintenance Parts screen or on the label on the reactor. With the system powered down,
remove and discard the lamp key from the controller. The replacement lamp is packaged with a
lamp key on the connector at the end of the lamp. Remove the key from the lamp and place it in
the controller. Refer to Installaon, starng with step 11 (page 11) for instrucons on installing
the new lamp.
QR Codes
A QR code (Quick Response code) is a matrix barcode rst designed for the
automove industry. RainHarvest Systems uses the QR code to store a link
to a specic page on our website. Users with a camera phone equipped with
the correct reader applicaon can scan the image of the QR code and over a
wireless network connect to a RainHarvest Systems web page in the phone’s
browser. RainHarvest Systems’s QR webpage has informaon on how to pur-
chase replacement components as well as a helpful video directory on system
servicing (i.e. How to change a UV lamp or quartz sleeve). To access the QR code
on the controller, press the control buon unl the QR code screen appears.
Flow Meter
Coming Soon.