SETTING PROGRAM START TIMES
1) Rotate the dial to program “START
TIMES”.
2) Choose program A, B or C. To change
program from existing program, push the
PRG button.
3) Use the + and – buttons to adjust to
desired start time. Start times are
available every 15 minute increment of
the hour. This represents the time of day
the irrigation cycle will commence. All
stations with programmed run time on this
program (A, B or C) will come on, one at a
time, sequentially, on all active days,
commencing at this time of day. Up to
three start times can be scheduled per
day.
4) Push the ? button to add another start
time or the PRG button to set the next
program.
5) If all 3 programmed start times are turned
“OFF” then that specific program will not
start.
6) To eliminate a start time, set dial to
“START TIMES”. Use the + button to
To Next Page
Loading...