MANUAL STATION
To manually activate a single station for one
watering cycle for a programmed length of time.
1) Rotate dial to “Manual Station”.
2) Push ? to desired station number.
3) Push + or – buttons to input length of
time, this station will now operate this
programmed time.
4) Rotate dial to “RUN” position, valve will
now turn on.
5) Upon completion of this station operating
manually for length of time programmed,
controller will revert back to “RUN” and
operate as previously programmed.
MANUAL PROGRAM
To manually activate one complete cycle of either
program “A”, “B” or “C”.
1) Rotate dial to “Manual Program”.
2) Choose program A, B, or C. To change
program from existing program, push the
PRG button.
To Next Page
Loading...