Pro2-Series 3D Printer
/ Quick Start Guide
Open the “Utilities” tab on the screen and
set the temperature of the right nozzle for
the filament you're using, then press the
“Load” button.
Finish the feeding operation step by step
according to the instructions on the
screen.
NOTE: This document is set based on the
Raise3D PLA filament, delivered with the printer.
We advise that using the Raise3D PLA for this
initial setup and testing.
3
H. Dual-Extruder Print - Hardware Installation (continued)
01 02
03 04 05 06
07 08 09 10
11 12 13 14
15 16 17 18
19 20
21 22
23 2624 25
To Next Page
Loading...
