Pro2-Series 3D Printer
/ Quick Start Guide
B. Hardware Installation (continued)
Press the “Utilities” tab on the screen and set
the temperature of the left nozzle for the
filament that you're using.
Press the “Load” button and the printer will
begin to heat. When the target temperature is
reached, press "Load". Complete the feeding
operation according to the instructions on the
screen.
NOTE: This document's instructions are based on the
properties of Raise3D PLA filament. This is the
standard filament included with your product and it is
advised to use the Raise3D PLA for testing and initial
setup.
16
01 02
03 04 05 06
07
08 09 10
11 12 13 14
15 16 17 18
19 20 21 22
23 2624 25
27
To Next Page
Loading...
