Pro2-Series 3D Printer
/ Quick Start Guide
B. Hardware Installation
Locate the four shipping zip ties, and remove
them.
It's recommend to unclip these as opposed to
cutting. They can be reused if you need to
transport your machine in the future.
1
3
Remove!
(×2) Hex Wrench
(3 mm)
Select the largest of the included hex head
wrench (3mm), and remove all four hex head
security bolts from Z-axis clamps (2 bolts
each).
These are located on the left and right sides on
the printer on the ball screw thread.
Peel the yellow sticker and remove the 24
security spacers.
These clips are designed to hold the extruder
assembly in place during shipping and should
be saved for future transport. Do not operate
printer with clips installed.
2
Remove!
(×24)
Remove!
Plug the machine into a wall outlet using the
power adapter for your designated country. (5
included)
Flip the switch to power the unit on.
4
01 02
03 04 05 06
07 08 09 10
11 12 13 14
15 16 17 18
19 20 21 22
23 2624 25
27
To Next Page
Loading...
