SECTION 4 - CARRIAGE
Page 4-2
Rev B – June 2013
4.3
Remove the lower side guide roller bracket assemblies and the upper rollers from the guide frame. Slide the guide
frame into place and insert the lower nuts & bolts. Insert the tilt plate bolts through the back of the guide frame tilt plate
and the carriage floor vertical angles. Tighten the tilt plate bolts until they just make contact but can still turn freely.
Figure 3. Setting the guide frame in place.
MATERIAL LIST PART #
1. Carriage floor AFBUC050
2. Carriage guide frame AFCUC001
To Next Page
Loading...