SECTION 4 - CARRIAGE.
Rev B – June 2013
Page 4-12
4.11
To level the carriage, adjust each tilt plate bolt in sequence until the deck is level or tilted slightly up(approx. ¼”) on the
side opposite the guide frame and all of the bolts have the same amount of tension. Do not adjust the bolts more than
a ½ turn at a time.
4.12
Once the carriage floor is level proceed to tightening all of the carriage studs making sure that the factory set markings
line up on each stud as this will make installing the trim panels easier.
4.13
Once the carriage studs are tight proceed to installing the carriage trim pieces using the 1/8 pop rivets provided.
Figure 10. Tightening the carriage bolts.
To Next Page
Loading...