20. Attach mounting angles (items 4 & 5)
using six capscrews (item 32) with
lockwashers and capscrews (items 35
& 31). Torque capscrews to 34 ft. lb.
(46Nm). each. Insert plug (item 54).
Into bottom of gear housing. Permatex
may be applied to threads to help
prevent leakage.
Pour ¾ pint of EP 140 gear oil into
housing thru hole in top of housing.
Insert relief fitting (item 50) into
reducer (item 53). Reducer should
then be placed into hole on top of gear
housing. Tighten fitting and reducer
securely.
WARRANTY
RAMSEY WINCHES - ONE YEAR LIMITED WARRANTY
BHW GROUP LTD the authorised Ramsey Servicing Distributor in the UK and Ireland
warrants each new winch and ancillary equipment supplied against factory defects in
material and workmanship for one year from date of purchase.
The responsibility for removing the winch or ancillary equipment is the owner's together
with its return, transportation prepaid to BHW Group Ltd.
BHW Group Ltd will, under this Warranty, without charge repair or replace at its option,
parts which on inspection are deemed to be defective. The loss of use of the produce, loss
of time, inconvenience, commercial loss or consequential damages are not covered.
Warranty does not apply where the product has been tampered with or altered in any way,
or where the serial number or date stamp has been defaced, altered or removed, or if in
the view of BHW Group Ltd the damage or failure occurred from misuse, negligence or
accident.
THIS WARRANTY EXCLUDES THE WIRE ROPE
Ramsey Winch Co. and BHW Group Ltd reserve the right to change the design of any
product without assuming any obligation to modify any product previously supplied.
Winches or equipment returned under warranty should be despatched to BHW Group Ltd
Service Department at the address indicated below, with full name and address of sender,
and a statement detailing the defect.
To Next Page
Loading...