FM100B • 15
Connectors
1 3-pin Molex connector (J1)
2 4-pin Molex connectors (J2,3)
4 5-pin 0.1” center connectors (J4,8,10,11)
1 Stereo jack, 3.5 mm for microphone (J5)
1 RCA jack module (J6)
1 Chassis mount BNC connector and mounting nut (J7)
Miscellaneous
5 Push-button switches (S1,2,3,4,5)
1 Mini speaker (SP1)
1 7.6 MHz Crystal (X2)
1 8” piece of black 18 AWG with Molex pin pre-crimped
1 7” piece of thin RG-174/U coax with BNC connector
1 Whip antenna (ANT1), low power version only.
1 +/-12V Switching Power Supply (PS1)
1 RF coil tuning tool
Case and knob parts
5 Push button switch caps
3 Set screw knobs
1 Bottom case half with pre-attached membrane panel
1 Top case half
17 4-40x1/4” board mounting screws
4 4-40x5/8” standoffs
6 6-32x1/4” self tapping black case screws
2 4-40x1/2” self tapping black machine screws
1 Fuse holder with hardware
1 1 Amp fuse
1 110 Volt line cord with plug and pre-installed Molex pins
1 Line cord grommet (black plastic - MP5P4)
1 Antenna grommet (black rubber ring)
4 Rubber leg pads
1 4-40 Kepnut
Other Equipment (Not included)
1 Pencil type soldering iron (30-40 Watts) Don’t use a solder gun!
1 Roll of fine 60/40 solder (less than .045” diameter)
1 Sensitive voltmeter or DMM
1 An FM radio for testing
1 Audio sources such as a tape deck, CD player, or microphone
1 Egg carton or grapefruit holder to sort out parts in.
To Next Page
Loading...
