FM100B • 37
12G. Install C63, a 39 pF ceramic capacitor (marked 39).
13G. Install C59, a 0.001 uF ceramic capacitor (marked 102).
14G. Install C67, a 27 pF ceramic capacitor (marked 27).
15G. Install L4, a 4 turn pre-wound inductor.
16G. Install C64, a 75 pF ceramic capacitor (marked 75).
17G. Install L5, the last of the 4 turn pre-wound inductors.
18G. Install C68, a 47 pF ceramic capacitor (marked 47).
19G. Install C44, a 0.01 uF ceramic capacitor (marked 103).
20G. Install C46, a 0.001 uF ceramic capacitor (marked 102).
21G. Install C45, a 100 uF electrolytic capacitor. Pay very close attention
to the orientation of this large capacitor, it must be installed correctly!
22G. Install L8, 13 turn air core inductor.
23G. Install the whip antenna with the provided screw (Std. version only).
24G. Solder the whip antenna screw in place on the bottom side of the
board. This may take a bit of time due to the heat that must be transferred
from your soldering iron to the large metal area you are working on. This
will allow you to remove the antenna at a later time while keeping the
mounting screw captured (Std. version only).
25G. Remove the whip antenna until the later casing instructions (be care-
ful, it’s hot!).
Jump to the High Power Manual (FM100BEX) if you have purchased that ver-
sion. Install the High power parts before moving on to Section H.
To Next Page
Loading...
