To Next PageTo Next Page
Need help?Do you have a question about the R&S EMC32 and is the answer not in the manual?
General| Brand | R&S |
|---|---|
| Model | EMC32 |
| Category | Motherboard |
| Language | English |
Details the intended purpose and receiver types for EMI tests.
Lists relevant standards like CISPR 25 for EMI testing.
Explains how to add necessary devices like receivers and antennas to the list.
Introduces the EMI Automotive Test Template Editor for test case configuration.
Provides steps to open or create a new EMI Automotive test template.
Details the configuration of a radiated EMI test template.
Describes the upper section for general settings and report configuration.
Explains the middle section listing defined sub-ranges for measurement.
Details the lower section with tabs for test setup, sub-ranges, graphics, etc.
Explains how mouse buttons interact with device icons and text boxes for configuration.
Guides on configuring the "Test Setup" tab for transducers, signal paths, and receivers.
Details settings for frequency, properties, detectors, and detector mode.
Explains how to set limit lines and display options for graphics.
Describes options for peak search, acceptance analysis, and maxima limitation.
Explains how to define actions like "Program a Device" or "Wait" for test sequences.
Guides on saving the configured EMI Automotive Test Template.
Explains how to switch to and use the measurement mode for test execution.
Describes the simple mouse click action to start a test.
Details the graphical elements visible during test execution.
Explains the toolbar buttons for controlling test execution (start, stop, pause, etc.).
Describes how result tables are generated for each band after test execution.
Provides historical context and development of EMC32-K51.
Explains how to switch between analysis and measurement modes.
