R&S EMC32 - Creating Reports

Creating Reports
01.00 Rohde & Schwarz EMI Automotive Band Evaluation with R&S©EMC32-K51 – 1SP07- 35
Figure 41: After end of test all data are collected in result tables including tables
with the outcome of data reduction per Band
Table 4-2: Description of the naming convention for tables
Table name
Description
<Sub-range name>_Auto
This table contains the measurement values
<Sub-range name>_DR_D1
This table contains the result of the Data Reduction
acc. to limit line 1 and detector 1 (if data reduction is
enabled)
<Sub-range name>_DR_D2
This table contains the result of the Data Reduction
acc. to limit line 2 and detector 2 (if data reduction is
enabled)
Result Table
Active table for the next measurement. After test stop
this table is empty.
Table 4-3: Naming convention for graphics
Graphics name
Description
<Sub-range name>
For each sub-range one graphics is generated
<Test template name>
This graphics is ready to take over the trace of the
next measurement. It is only visible in measurement
mode, in analysis mode it can be floating.
5 Creating Reports
We start with an empty Report setup in the report generator.