Running an EMI Band Evaluation Test
01.00 Rohde & Schwarz EMI Automotive Band Evaluation with R&S©EMC32-K51 – 1SP07- 26
Figure 30: Settings in the New Test Editor overrides those from template
Figure 31: Start a new test via the Tool Bar
To run the test we have to switch to Measurement mode.
4.1 Measurement Mode
The measurement mode is used for performing test runs and acquiring measurement
data.
After selecting a test from Test Template, the template will be open in Analysis mode.
When pressing the "Switch to measurement mode" or F4 button. It will leave the
analysis mode and will switch to Measurement Mode.
To Next Page
Loading...