R&S QPS Walk2000 - Scanner Tour; Gate Controls and Connectors

Scanner tour
R&S
®
QPS Walk2000
15Getting Started 1179.5782.02 ─ 03
4 Scanner tour
The R&S QPS Walk2000 is a millimeter wave imaging system that uses an ultra wide
band (UWB) signal to create a 3D structure of people walking through the gate.
The complete system consists of the following components:
●
A gate that contains all the measuring electronics and a computer that controls the
software for the user interface.
●
A touchscreen to operate the system using a graphical user interface (GUI).
●
A server that processes the captured data.
Parts of delivery
●
1 x gate (incl. floor plate)
●
1 x server
●
1 x touchscreen
●
1 x stand
●
4 x power cables
●
1 x HDMI cable
●
1 x USB cable
●
1 x optical fiber cable
● Gate controls and connectors................................................................................. 15
● AC power supply.....................................................................................................16
● Gate power button...................................................................................................17
● GUI power button....................................................................................................17
● Optical fiber connector (J1).....................................................................................17
● HDMI connector (J2)...............................................................................................17
● USB connector (J3).................................................................................................17
● LAN port (J4)...........................................................................................................17
● Signposts (status lights)..........................................................................................18
● Device ID.................................................................................................................18
4.1 Gate controls and connectors
The R&S QPS Walk2000 has several controls and connectors. All controls and con-
nectors are located behind a protective cover on the side of the master panel. You can
open the protective cover by pulling it downward by the handle.
Gate controls and connectors