To Next Page

To Previous Page

Maintenance

R&S

QPS Walk2000

24Getting Started 1179.5782.02 ─ 03

Make sure that the platform does not become too damp during cleaning. Remove any

escaped liquid (including water) immediately.

Do not clean the platform with a machine.

Server

Clean the server with a lint‑free duster.

Touchscreen

Clean the touchscreen using a soft, lint‑free dust rag. Do not use chemical cleaning

agents or solvents (alcohol, acetone, cellulose lacquer thinners or similar agents).

Remove fingerprints with a mild glass cleaner.

6.3 Replacing fuses

The power supply of the R&S QPS Walk2000 has two fuses. In case one of them

blows, you can replace it with a fuse by the same type and rating. The fuse type is: IEC

60127-2/5 T10H/250 V.

WARNING! Risk of electric shock. The fuse is part of the main power supply. Han-

dling the fuse while the R&S QPS Walk2000 is connected to the power source can

cause an electric shock.

Disconnect the R&S QPS Walk2000 from the power source.

2. Open the hatch of the AC power supply with a flat head screwdriver.

The fuse holder hatch opens downwards.

3. Take out the fuse holder.

4. Check the condition of the fuse.

5. Replace the blown fuse.

6. Insert the fuse holder in the power supply.

7. Close the hatch.

8. Reconnect the R&S QPS Walk2000 to the power source.

6.4 Storage

Protect the R&S QPS Walk2000 against dust. Ensure that the environmental condi-

tions, e.g. temperature range and climatic load, meet the values specified in the data

sheet.

Storage

R&S QPS Walk2000 User Manual

Questions and Answers: