Safety and regulatory information
R&S
®
QPS Walk2000
6Getting Started 1179.5782.02 ─ 03
lation, make sure that the installation site is only accessible by people working on the
installation.
The R&S QPS Walk2000 gate elements, the floorplate, the transport boxes and the
server are heavy. Lifting and carrying heavy items can cause structural or muscular
injuries. Heavy items can also cause other physical injuries like crushed body parts
when they fall or tip over.
Because of its weight, at least two strong people are required to install or disassemble
the system. If you have to move the pallets the R&S QPS Walk2000 is delivered on,
always use a forklift.
The transport box is made of wood that can pose a risk of drawing splinters.
During transport, installation, disassembly or repair, wear appropriate protective cloth-
ing that complies with your local rules and regulations. If you are unsure of which
equipment to use, ask your safety inspector.
We recommend to wear:
●
Safety shoes with toe cap and ESD protection.
●
Protective gloves
ESD protected shoes and gloves also protect the hardware from being damaged.
Installing cables
A R&S QPS Walk2000 installation consisting of the gate, operator touchscreen and
server requires cable connections (power cables, LAN cables etc.). Secure all cables
on the floor and cover them up.
Loose cables are a tripping hazard. Tripping on cables can cause physical injuries.
Properly covered cables also minimize the risk of cable damage.
Choosing the operating site
Only use the product indoors. The product casing is not waterproof. Water that enters
can electrically connect the casing with live parts, which can lead to electric shock,
serious personal injury or death if you touch the casing. If Rohde & Schwarz provides
accessories designed for your product, e.g. a carrying bag, you can use the product
outdoors.
Unless otherwise specified, you can operate the product up to an altitude of 2000 m
above sea level. The product is suitable for pollution degree 2 environments where
nonconductive contamination can occur. For more information on environmental condi-
tions such as ambient temperature and humidity, see the data sheet.
Connecting to power
The product is an overvoltage category II product. Connect the product to a fixed
installation used to supply energy-consuming equipment such as household applian-
ces and similar loads. Keep in mind that electrically powered products have risks, such
as electric shock, fire, personal injury or even death.
Safety instructions
To Next Page
Loading...
