R&S ZNA26 - Page 12

Contents
R&S
®
ZNA
12User Manual 1178.6462.02 ─ 20
7.3.11 MMEMory commands................................................................................................1176
7.3.12 OUTPut commands...................................................................................................1217
7.3.13 PROGram commands...............................................................................................1222
7.3.14 [SENSe:] commands.................................................................................................1225
7.3.15 SOURce commands................................................................................................. 1408
7.3.16 STATus commands................................................................................................... 1480
7.3.17 SYSTem commands..................................................................................................1483
7.3.18 TRACe commands....................................................................................................1519
7.3.19 TRIGger commands..................................................................................................1522
7.3.20 New commands for R&S ZNA...................................................................................1532
7.4 HUMS and service date commands...................................................................... 1544
7.4.1 SNMP/REST commands...........................................................................................1544
7.4.2 System information commands.................................................................................1548
7.4.3 Device tags commands.............................................................................................1558
7.4.4 Utilization commands................................................................................................ 1559
7.4.5 Service date commands............................................................................................1562
7.5 R&S ZVR/ZVABT compatible commands..............................................................1564
8 Programming examples.................................................................. 1590
8.1 Basic tasks.............................................................................................................. 1590
8.1.1 Typical stages of a remote control program.............................................................. 1590
8.1.2 Channel, trace and diagram handling....................................................................... 1593
8.2 Condensed programming examples..................................................................... 1599
8.2.1 Path-independent remote control programs..............................................................1600
8.2.2 Trace and diagram handling......................................................................................1600
8.2.3 Using markers........................................................................................................... 1609
8.2.4 Data handling............................................................................................................ 1611
8.2.5 Calibration................................................................................................................. 1615
8.2.6 Mixer measurement.................................................................................................. 1624
8.2.7 RFFE/GPIO interface programming..........................................................................1626
8.2.8 Fixture modeling........................................................................................................1628
8.2.9 Noise figure measurement of an amplifier................................................................ 1629
9 Error messages and troubleshooting............................................ 1632
9.1 Errors during firmware operation..........................................................................1632