R&S ZNA26 - Page 1480

Command reference
R&S
®
ZNA
1480User Manual 1178.6462.02 ─ 20
Suffix:
<Ch>
.
Channel number
<Pt> Port number
Parameters:
<Path> NONE | B16 | REV | SRC
Direct access signal path
Manual operation: See "Receiver Input" on page 622
7.3.16 STATus commands
The STATus:... commands control the status reporting system. Status registers are
not reset by *RST; use *CLS for this purpose.
STATus:PRESet...........................................................................................................1480
STATus:QUEStionable[:EVENt]?....................................................................................1481
STATus:QUEStionable:INTegrity[:EVENt]?......................................................................1481
STATus:QUEStionable:INTegrity:HARDware[:EVENt]?.....................................................1481
STATus:QUEStionable:LIMit<Lev>[:EVENt]?...................................................................1481
STATus:QUEStionable:CONDition?................................................................................1481
STATus:QUEStionable:INTegrity:CONDition?..................................................................1481
STATus:QUEStionable:INTegrity:HARDware:CONDition?.................................................1481
STATus:QUEStionable:LIMit<Lev>:CONDition?...............................................................1481
STATus:QUEStionable:ENABle..................................................................................... 1481
STATus:QUEStionable:INTegrity:ENABle........................................................................1481
STATus:QUEStionable:INTegrity:HARDware:ENABle.......................................................1482
STATus:QUEStionable:LIMit<Lev>:ENABle.....................................................................1482
STATus:QUEStionable:NTRansition...............................................................................1482
STATus:QUEStionable:INTegrity:NTRansition................................................................. 1482
STATus:QUEStionable:INTegrity:HARDware:NTRansition................................................ 1482
STATus:QUEStionable:LIMit<Lev>:NTRansition..............................................................1482
STATus:QUEStionable:PTRansition............................................................................... 1482
STATus:QUEStionable:INTegrity:PTRansition................................................................. 1482
STATus:QUEStionable:INTegrity:HARDware:PTRansition................................................ 1482
STATus:QUEStionable:LIMit<Lev>:PTRansition.............................................................. 1482
STATus:QUEue[:NEXT]?.............................................................................................. 1483
STATus:PRESet
Configures the status reporting system such that device-dependent events are repor-
ted at a higher level.
The command affects only the transition filter registers, the ENABle registers, and
queue enabling:
●
The ENABle parts of the STATus:OPERation and STATus:QUEStionable... reg-
isters are set to all 1's.
●
The PTRansition parts are set all 1's, the NTRansition parts are set to all 0's,
so that only positive transitions in the CONDition part are recognized.
SCPI command reference