R&S ZNA26 - Page 1429

Command reference
R&S
®
ZNA
1429User Manual 1178.6462.02 ─ 20
Port-specific and general settings
The SOURce:POWer... subsystem comprises port-specific and general settings.
Port-specific settings are valid for the port specified by the numeric suffix <PhyPt>
(...:POWer<PhyPt>:...). General settings are valid for all test ports of the ana-
lyzer; the port suffix is ignored. Refer to the description of the individual commands for
more information.
SOURce:POWer:ALC...
The following commands set up the automatic level control (ALC).
SOURce<Ch>:POWer:ALC:AUBW................................................................................ 1429
SOURce<Ch>:POWer:ALC:BANDwidth......................................................................... 1430
SOURce<Ch>:POWer:ALC:CSTate............................................................................... 1430
SOURce<Ch>:POWer<Pt>:ALC:COUPle....................................................................... 1431
SOURce<Ch>:POWer<Pt>:ALC:OPTimize..................................................................... 1431
SOURce<Ch>:POWer<Pt>:ALC:PIParameter.................................................................1431
SOURce<Ch>:POWer:ALC:PIParameter:ASETtling........................................................ 1432
SOURce<Ch>:POWer:ALC:PIParameter:CTIMe............................................................. 1432
SOURce<Ch>:POWer<Pt>:ALC:PIParameter:GAIN........................................................ 1432
SOURce<Ch>:POWer<Pt>:ALC:PIParameter:ITIMe........................................................1433
SOURce<Ch>:POWer<Pt>:ALC:RANGe........................................................................1433
SOURce<Ch>:POWer<Pt>:ALC:RECeiver..................................................................... 1433
SOURce<Ch>:POWer<Pt>:ALC:SOFFset...................................................................... 1434
SOURce<Ch>:POWer<Pt>:ALC[:STATe]........................................................................ 1434
SOURce<Ch>:POWer:ALC:STOLerance........................................................................1435
SOURce<Ch>:POWer<Pt>:ALC:TPOWer.......................................................................1435
SOURce<Ch>:POWer<Pt>:ALC:TPOWer:DEFault..........................................................1435
SOURce<Ch>:POWer<Pt>:ALC:VNETwork....................................................................1435
SOURce<Ch>:POWer:ALC:AUBW <Boolean>
Enables or disables automatic IF bandwidth setting for the ALC path in channel <Ch>.
Set SOURce<Ch>:POWer:ALC:AUBW to OFF and use SOURce<Ch>:POWer:ALC:
BANDwidth to set the bandwidth manually.
Suffix:
<Ch>
.
Channel number
Parameters:
<Boolean> ON (1)
Enables automatic bandwidth setting for ALC in channel <Ch>.
OFF (0)
Disables automatic bandwidth setting for ALC in channel <Ch>.
*RST: ON
SCPI command reference