GUI reference
R&S
®
ZNA
640User Manual 1178.6462.02 ─ 20
For unsuitable combinations of the pulse and measurement settings, the firmware dis-
plays a warning above the diagram, indicating the detection type and a possible desen-
sitization loss of sensitivity of the measurement.
Master pulse settings
Pulse Gen.
Enables or disables pulse generation.
Remote command:
[SENSe<Ch>:]PULSe:GENerator<Id>[:STATe]
Master Pulse Clock Source
Defines whether the Master Pulse is provided internally or externally (via any of the
available Trigger In interfaces).
Remote command:
[SENSe<Ch>:]PULSe:GENerator:SOURce
Pulse Period
Defines the (common) pulse period of the internal pulse generators (Master Pulse
Clock Source set to "Internal").
Mode softtool
To Next Page
Loading...
