Operating the instrument
R&S
®
ZNA
47Getting Started 1178.6456.02 ─ 18
trace. The following section presents some of the graphical tools the R&S ZNA pro-
vides for trace and marker handling.
For further reference
Refer to chapter "Concepts and Features" in the R&S ZNA Help or in the User Manual
to learn more about traces, channels, and screen elements.
5.5.1 Adding new traces and diagrams
A new trace is required if you want to measure and display an additional quantity.
Typical scenario: The transmission coefficient S
21
is measured as described in Chap-
ter 6.1, "Transmission S-parameter measurement", on page 62. A trace is added to
display the reflection coefficient S
11
for comparison.
To create a trace:
1. Drag the "Trc+" icon from the toolbar into a diagram.
The diagram changes its color scheme and contents as shown below.
2. Select the adequate drop position, depending on whether you want to display the
new trace in the existing diagram, or whether you want to add a new diagram. The
highlighted area indicates the target diagram.
Handling diagrams, traces, and markers
To Next Page
Loading...
