Operating Instructions RS cure │ D cure │ P cure │ SHERAprint cure │ 3Decure
Rapid Shape GmbH │ DOCR000251
3.1 Safety during Transport
NOTE!
Material damage caused by improper transport!
Improper transport may cause the machine to fall. This
can cause material damage.
— Only transport the machine with the packaging
provided.
— In the event of subsequent transport of the
machine, make sure that the exposure chamber is
empty before starting the transport.
3.2 Transporting the Machine
Check the transport packaging immediately upon receipt for any visible
damage. Damage must be recorded in written and image form and
then immediately reported to the transport company and Rapid Shape.
The machine can be transported by one person.
1. Grasp the bottom of the transport packaging and transport it to
the destination
2. Then unpack the machine. → Chapter 3.3
NOTE!
Do not turn over the transport packaging during
transport. This can lead to material damage to the
machine.
3.3 Unpacking the Machine
For unpacking the machine please proceed as follows:
1. Open the transport packaging. The machine is protected
against vibration with foam rings.
2. Grasp into the packaging from the top. Grasp the machine
directly on the housing!
3. Lift the machine out of the transport packaging.
4. Then set up the machine. → Chapter 4.2
Store all parts of the transport box safely for future
transport of the machine.
To Next Page
Loading...