Operating Instructions RS cure │ D cure │ P cure │ SHERAprint cure │ 3Decure
Rapid Shape GmbH │ DOCR000251
9.1 Safety Instructions for Disassembly & Disposal
DAN GER!
Danger to life due to electric current!
There is an imminent danger of electrocution
in the event of contact with live parts.
— Before starting disassembly work, the power supply
must be finally disconnected:
WA RNIN G !
Risk of injury due to improper disassembly!
Stored residual energy, sharp, pointed components and
tools can cause injuries.
— Disassembly work may only be carried out by
qualified personnel.
— Sufficient space must be ensured before the
disassembly work begins.
— Wear appropriate protective clothing.
— Disassemble components properly.
— Handle edged and pointed components carefully.
— If necessary, secure components so that they can
not fall down during work.
— In case of doubt, please contact the Customer
Service.
9.2 Disassembling the Machine
To disassemble the machine, please proceed as follows:
1. Switch off the machine. → Chapter 7.1
2. Disconnect the power supply.
3. Open the lid and, if present, remove any components or
platforms from the exposure chamber.
4. If present, remove any soiling.
5. Disassemble the machine properly.
9.3 Disposing the Machine
Dispose of the machine as intended via your recycling agent or
approved specialist companies. For a list of materials used, please
contact Rapid Shape.
To Next Page
Loading...