Rapid Shape RS cure - Intended Use; Digital Workflow

Operating Instructions RS cure │ D cure │ P cure │ SHERAprint cure │ 3Decure
Rapid Shape GmbH │ DOCR000251
6 │ 27
Special Safety Instructions
In order to draw attention to particular dangers, the following symbols
are used in safety notices:
Warning: Dangerous electrical voltage
Warning: Hand injuries
Tips & Recommendations
This symbol highlights useful tips and recommendations,
as well as information for efficient and trouble-free
operation.
1.2 Intended use
The post curing unit is intended for the curing of light-curing plastic.
The digital workflow is to be observed. (→ Chapter 1.2.1)
The post curing unit is designed for temperature controlled interiors.
(→ Chapter 10)
Proper use requires compliance with all information in this manual.
Any use going beyond the intended use or otherwise is deemed to be
improper. The operator is exclusively liable for any resulting damage.
Use contrary to the intended use includes, but is not limited to the
following actions:
— Operation within potentially explosive areas
— Operation with explosion-hazardous printing materials
— Outdoor operation
— Operation in tropical climates
— Operation in wet, damp rooms
— Operation without sufficient instruction
— Operation with defective or modified safety devices
— Operation without mandatory safety equipment
— Operation with unauthorised spare parts
— Improper conversions, modifications, repairs and maintenance
1.2.1 Digital Workflow
1
Creation of
3D data
2
Processing
the 3D data
3
Preparation
of 3D data
for the printer
system
4
Printing the
3D compo-
nents
5
Post-
processing
6
Use of the
component
The post curing unit described in these operating instructions is part of
the digital workflow and is used in step 5.