DAN GER!
Danger to life due to electric current!
Incorrect connection, insulation faults, foreign objects
(dust, liquid due to inappropriate installation environ-
ment) or lack of grounding can lead to housing parts
being live. There is an imminent danger of electrocution
in the event of contact with live parts
— Work on the electrical equipment may only be
carried out by qualified electricians and in
compliance with the relevant safety and VDE
regulations.
— Machines with damage to the power cord, in-
sulation or lack of earthing must be disconnected
from the mains immediately. Repairs are to be
made immediately.
— Only operate the machine with the mains voltage
specified for the machine.
— Only operate the machine with the power supply
unit supplied
— The mains plug must be freely accessible at all
times. A complete separation of the machine from
the mains in an emergency by pulling out the
power plug (→ Chapter 5).
— Keep moisture away from live parts. This may lead
to short circuiting.
For the smooth functioning of the machine, please note the following
requirements at the installation location:
— dust protected room
— protection against direct sunlight (window equipped with UV
protection film)
— UV-protected exposure
— stable base (table)
— Internet connection (LAN/WLAN)
The following optional requirements are recommended:
— Air conditioned environment
For setting up the machine please proceed as follows:
1. Prerequisite: The machine has already been unpacked.
→ Chapter 3.3
2. Lift the machine to the desired installation location and set it
down.
To Next Page
Loading...