Operating Instructions RS cure │ D cure │ P cure │ SHERAprint cure │ 3Decure
Rapid Shape GmbH │ DOCR000251
8.1 Safety during Cleaning and Maintenance
CA UT ION !
Risk of injury due to moving parts!
The machine consists in part of accessible parts that can
easily cause hand injuries through crushing or getting
caught.
— When closing the machine, do not insert any
fingers behind the shock absorbers and into the
support area of the lid.
NOTE!
Material damage due to incorrect cleaning and
maintenance!
Observe the individual cleaning and maintenance steps
to avoid material damage to the machine.
8.2 Overview of the Cleaning & Maintenance Work
Check glass bottom
and seal
The cleaning and maintenance of the machine is an
integral part of a properly functioning machine. It is
therefore essential to observe the prescribed cleaning
and maintenance work.
8.2.1 Check & Clean the Glass Bottom & Seal
Required accessories:
Personnel:
Microfibre cloth, glass cleaner/isopropanol,
protective gloves
Operator
For checking and cleaning the glass bottom and the seal, please
proceed as follows:
1. Put on protective gloves.
2. Open the lid.
3. Check the surrounding seal for soiling. Remove dirt with a
microfibre cloth moistened with glass cleaner or isopropanol.
4. Check the glass bottom for soiling. Remove light dirt with a
To Next Page
Loading...