Rapid Connect - How Do I Handle Alarms

INSTRUCTION MANUAL IB 109050 02 C03b
4:14
4. PORTAL
4.14. HowdoIhandlealarms?
Alarms for a machine can be handled in the web portal. When an alarm is raised, a symbol is
displayed on the company and/or department level, to indicate that a machine within the company
and/or department has an active alarm.
The type of alarm that is active can be seen on the machine level. The type of alarm is indicated by
a symbol. Following symbols can be shown.
An emergency stop is activat-
ed.
The machine’s hopper jack is
overloaded.
The granulator’s main motor is
overloaded.
The infeed equipment’s main
motor is overloaded.
The blower’s main motor is
overloaded.
The machine is overheated.
The shredder is overloaded. Hydraulic pump is overloaded.
The granulate bin is full.
A description of the alarm is displayed in the alarm list. The alarm list shows the type of alarm,
when the alarm was raised, and for how long the alarm has been active.
The alarm list shows alarms that are currently active, or that have been active during the current
scope. The scope can be changed to show previous alarms, see section 4.9. on page 4:11.
When mousing over an item in the alarm list, a calendar button (
) is displayed on the item line.
The calendar button, when clicked, sets the scope to the time that the alarm was active.