32
all-pole disconnection device with a minimum of
a 3 mm contact gap. If the UV shall be connected
with a plug make sure that it is accessible.
> The UV must be protected on site with a maxi-
mum fuse of 16 A.
> The UV is fitted with a cable approx. 2 m in
length without plug.
> If the power cord shall be changed, the quality of
the cord must be at least H05 RN-F 3x1,5 mm2
> In case the power cable must be changed use a
cable that matches your local standards.
The exchange of the power cable may only be
carried out by the manufacturer, his service
agents or similar qualified personal
Installation instruction
To Next Page
Loading...
